Skip navigation
Banner

programing a Vertex vx-6000 with a CNT-5000 head

Post

Hi I'm having problems programming a vx-6000 with a cnt-5000 motorcycle head. It says to turn on the power and press and hold the PF button at the same time to get it into cloning mode. There is no PF button on here.

Hi I'm having problems programming a vx-6000 with a cnt-5000 motorcycle head. It says to turn on the power and press and hold the PF button at the same time to get it into cloning mode. There is no PF button on here. Any help would be greatly appreciated. 
Back to the top

Post

That sounds to me like you may be using the wrong software. I have run into a similar issue just recently with a Vertex mobile. Thought I had the correct software and turns out that I did not. WOOPS. Hope this helps a bit.
Back to the top
1 guest and 0 members have just viewed this.