Skip navigation
Banner: Jump directly to the Hamfiles Site News Forum

Looking for Kenwood nx3220 software

Post

Kenwood nx3220 software wide band

Looking for someone that may be able to help find somewhere to purchase this software for wide band 
Back to the top

Post

Kenwood does not offer the software in wideband.  Unless you find a way to modify the software for wideband then you are out of luck.  
Back to the top

Post

where are you trying to use the wide band i just tested it here and i was able to get the radio to take the ham band in wide

boldly going no where
Back to the top

Post

oh helps if i read the whole post lol are you in the states then i can help you with that but just for your information it is a software that you can only get from a kenwood dealer due to how the software is actavated

boldly going no where
Back to the top

Post

I have the software but have not tried it yet. will try upload it if you still want it.
Back to the top

Post

hi attie if you could that would be great still looking
Back to the top

Post

I am busy uploading it now and then just for it to be validated. will check for serial code for you as soon as its uploaded.
Back to the top

Post

I can get most software directly from Kenwood so just ask and ill try get it.
Back to the top

Post

Thank You it would be Greatly Appreciated !!
Back to the top

Post

thanks attie greatly appreciated
Back to the top

Post

I have bad news. Just found out that you have to buy a licence for the software and then it registers in Japan on their server your MAC adresss. So that means you cannot use same licence on different PCs. Sorry guys. All new software for Kenwoods are going to be like that now. Same for the NX5000 series.
Back to the top

Post

there must be away to that.may be there is cracked version for that .i will checked  around.:thumbs:

R.G TWO-WAY RADIO Elecctronic & consultant
Back to the top

Post

This is all new software and they are going to apply it to all other new software. If you can find it let me know. Thanx
Back to the top

Post

This apply to the 3000 series the 5000 series and the new nxr-5000 series repeaters along with a hand full of other software that is out now and i have been checking around and unless you can spoof the server on there end it may be software that will need to be end of life and no longer supported before it gets hacked and that will be possibly be 5-20 years before that may happen so far Kenwood has it locked up tight fort knox

boldly going no where
Back to the top

Post

Poptarrrrrt said

Kenwood does not offer the software in wideband.  Unless you find a way to modify the software for wideband then you are out of luck.  

KPG-D3 is for wideband and KPG-D3N is narrow.
Back to the top
1 guest and 0 members have just viewed this.